This week, we continue our "Yoctopuce for beginners" post series. We are going to see how to test and configure a Yoctopuce module. More particularly, we are going to show you how to configure a YoctoHub-Wireless-g so that it connects itself to a wireless network.
Let's imagine an isolated house, unoccupied most of the time, with the heater set to the minimum to prevent pipes from freezing. No Internet, no phone... only electricity. How to make sure, without going there, that: a/ the boiler has not broken down , b/ no one settled in inside the said house without your knowledge? We had a few ideas...
There is a newcomer in the family of Yoctopuce interface modules: the Yocto-SPI. This small module can communicate with sensors and other devices that use a SPI communication protocol.
To integrate a Yoctopuce sensor into an application, you can use our libraries to communicate directly with the Yoctopuce module. It's the most efficient manner, which also offers the most possibilities. But to do so, you need a minimum of programming knowledge. The other solution is to use a standard protocol and applications which support this protocol. It's the case of MQTT. We just added MQTT support into the VirtualHub and the YoctoHubs.
1 ... 10 ... 20 ... 30 ... 40 ... 50 ... 52 53 54 55 56 57 58 59 60 61 62 ... 70 ... 80 ... 90 ... 100 ... 106