The YoctoHub-GSM-2G is a wireless-enabled module that can host three Yoctopuce modules to access them remotely through a 2G GSM cellular network (using GPRS EDGE, aka 2.75G). You can power it either with a Micro-B USB cable and a regular phone charger, or a 5V battery pack.
The radio module supports the four most common GSM frequency bands, i.e. 900 MHz and 1800 MHz bands used in Europa, Middle-East, Africa, Asia and Pacific, and 850 MHz and 1900 MHz bands used in North-America, Caribbean and Latin America. For a detailed list of frequency bands supported in each country, please refer to the Wikipedia page GSM_frequency_bands. Be aware that although GSM 2G network still has the widest worldwide coverage, in some countries the 2G network is starting to be replaced by new technologies with more bandwidth. You might therefore be interested in the YoctoHub-GSM-3G-EU or the YoctoHub-GSM-3G-NA.
You can use the YoctoHub-GSM-2G in the same way as a VirtualHub running on a little computer, but it is much easier to setup and maintain than a computer. It is smaller and consumes less. It is compatible out-of-the-box with all existing applications using Yoctopuce API. As for the VirtualHub, it can run autonomously using HTTP callbacks.
Moreover, the YoctoHub-GSM-2G features a built-in clock timer, that makes it possible to put the device into low-power deep sleep and wake-up automatically at predefined times. This makes it possible to reduce power consumption to 15uA while sleeping, which is crucial for applications running on battery or solar panels. The YoctoHub-GSM-2G only needs a few seconds of wake-up time to post data on an web server using the HTTP callback.
You can connect three Yoctopuce modules directly, one of which can be fixed directly on the YoctoHub-GSM-2G and connected using a Board2Board-127 connector. More devices can be connected, thanks to the YoctoHub-Shield extension. The YoctoHub-GSM-2G can power Yoctopuce devices up to 2A.
The device is provided with an articulated antenna (9cm, with SMA connector) and a connection cable (uFL to SMA).
Warning: although the 3 downstream ports hosting Yoctopuce devices use micro-B USB connectors, the YoctoHub-GSM-2G uses a specific protocol simpler than USB to talk to the devices. Therefore, it is not possible to drive or even to power a regular (non-Yoctopuce) device using the YoctoHub-GSM-2G. It is not possible either to use a regular USB hub (such as the Micro-USB-Hub) on the downstream ports. If you need more downstream ports for Yoctopuce devices, you can use a YoctoHub-Shield.
USB cables and enclosures to be ordered separately.